Your position: Home > News

Installation Method of Ultrasonic Level Gauge

2020-11-23
 Installation Method of Ultrasonic Level Gauge
1. Bracket installation: Fix the L-shaped bracket horizontally above the liquid to be measured, and fix the liquid level meter on the bracket with screws.
2. Flange installation: When installing, first fix the flange on the iron plate or blind plate, and then fix the instrument on the flange.
Remote Type Ultrasonic Level Gauge Notes:

1. The distance from the transmitter surface of the transducer to the lowest liquid level should be less than the range of the optional instrument.
2. The distance from the transmitter surface of the transducer to the highest liquid level should be greater than the blind zone of the optional instrument.
3. The emitting surface of the transducer should be parallel to the liquid surface.
4. The installation position of the transducer should be avoided as far as possible from the position where the liquid level is violently fluctuating such as the inlet and outlet directly below.
5. If the pool or tank wall is not smooth, the meter should be more than 0.5m away from the pool or tank wall.
6. If the distance from the transmitter surface of the transducer to the highest liquid level is less than the blind zone of the optional instrument, an extension pipe must be installed. 
The extension pipe must be perpendicular to the liquid surface and the inner wall must be smooth.
 

share:

Pre: Analysis of Common Failure of Vortex Flowmeter
Next:Guided Wave Radar Level Gauge Installation Requirements